Kinetic Engineering Home     |     About Us     |     Contact Us     |     Site Map
rule
Products
rule

Heat Exchangers

Shell & Tube Heat Exchangers

Brazed Plate Heat Exchangers

Plate and Frame Heat Exchangers

TEMA Exchangers

Air & Gas After Coolers

Double Pipe Heat Exchangers

Multitube/Hairpin Heat Exchangers

Custom Process Heat Exchangers

Spiral Heat Exchangers

Double Tube Heat Exchangers

Standard Stainless Steel Air Coolers

Fin Fan Heat Exchangers

Plate Fin Heat Exchangers

Welded Plate Heat Exchangers

Plate Shell Heat Exchangers

Wide Gap Welded Heat Exchangers

Feed Water Heaters

Fired Process Heaters

Helical Coil/Serpentine Coil Heaters

Thermal Fluid Heaters

Convection Process Liquid Heaters

rule
Fired Process Heaters - Helical Coil/Serpentine Coil Heaters

HCI Thermal Fluid & Process Heaters
Two-pass helical coil heater with outputs from 0.5 to 60-million BTU/hour. Can be designed for thermal fluid or process heating. Available in horizontal and vertical configurations.

The Heatec HCI thermal fluid heater is an industrial heater commonly used in closed-loop thermal fluid heat transfer systems. The heater is designed around a helical coil. Thermal fluid flows through the helical coil, gaining radiant and convective heat from hot burner gases. The heated thermal fluid then transfers heat to end users such as tanks, presses, dryers, reactors, chillers, extruders, steam generators, or other equipment. The heater's two-pass design provides high efficiency, simplicity and low maintenance. Heating coils meet ASME code.

Three-Pass Helical Coil Heater
A very high efficiency thermal fluid heater. Has two helical coils, a smaller coil that fits inside of a larger coil.

A very high efficiency thermal fluid heater. The heater has two helical coils, a smaller coil that fits inside of a larger coil. Hot burner gases pass through the center of the smaller coil and double back between it and the larger coil. They then travel back between the outer diameter of the larger coil and the heater shell. Thus, the gases make three passes through the heater, transferring heat to thermal fluid that flows in the helical coils.

Heatec 3-pass heaters are available in horizontal and vertical configurations. Capacities range from 0.7 to 60 million BTU/hour.

Heatec's Vertical Serpentine Heater/Vaporizer
An upright heater that uses serpentine heating coils for thermal fluid. These heaters are used primarily in the food, chemical, petrochemical and petroleum industries. They can be used to heat almost any type of fluid. The vertical design allows the heater to occupy only a small ground area. Capacities range from 1 to 75 million BTU/hour.



Manufacturers
rule
rule

Heat Transfer Equipment

Standard Xchange

Heat Exchanger Design

Elanco

Fin-X

Super Radiator Coils

Premium Process Equipment

American Exchanger Services

rule

Fired Process Heaters

Heatec

rule

Need More Information?

Bob Hedrick
bob@kineticengineering.com

Andy (Andres) Diaz
andy@kineticengineering.com

Ken Stone
ken@kineticengineering.com



rule
© 2008 Kinetic Engineering Corporation Home     |     About Us    |     Heat Transfer Equipment    |     Fired Process Heaters     |     Contact Us